Homeowners' pick for appliance repair across Alabama
Dryer Repair — Book a Visit Today
We fix dryers across Alabama, and the fastest way to start is to tell us what yours is doing wrong. Clothes coming out damp, a thumping drum, a burning smell in the hallway: those are symptoms, and each points to a short list of parts. Heating element, thermal fuse, thermostat, blower wheel, belt, drum rollers, or a vent line packed with lint. Our visit starts with questions, then a look at airflow, heat, and motion, the systems that make a dryer work. We test before we replace. If the real problem is a crushed vent behind the wall, we tell you that instead of swapping parts. We repair all major brands as an independent shop. Call us and describe the behavior, and we'll narrow it down.
Call (800) 712-6387- Real people on the phone
- 7 days a week
- Quote in writing before any work
Taking calls until 5:00 PM CT
The dryer symptoms we hear most
- Runs a full cycle and clothes are still wet Restricted airflow or partial heat loss: clogged vent, weak blower, a failing element or thermostat
- Drum spins but there's no heat at all Open thermal fuse, burned heating element, bad high-limit thermostat, or half the 240V supply lost
- Loud thumping or squealing while it tumbles Worn drum rollers, a dry idler pulley, stretched belt, or a rear bearing giving out
- Smells hot or scorched near the laundry room Lint packed against the heater housing, or a blocked exhaust holding heat inside the cabinet
- Push start and nothing happens Door switch, start switch, motor centrifugal switch, or a control board that lost its signal
Safe things to check first
Worth a look before you call — sometimes it saves you the visit.
- 1Pull the lint screen, clean it, then check that the little metal flap outside your house opens when the dryer runs.
- 2Confirm the door latches all the way. A worn door switch stops everything, and so does a lazy latch.
- 3Look at the breaker panel. A dryer can tumble on one leg of power and still lose all its heat.
- 4Reach behind the machine and make sure the flexible vent hose isn't kinked, crushed, or pulled loose.
What homeowners get from an independent shop
| G Appliances MD | Big-box repair chains | Handyman listings | |
|---|---|---|---|
| Written quote before any work | ✓ | ✕ | ✕ |
| Live answer seven days a week | ✓ | ✕ | ✓ |
| Every major brand, gas or electric | ✓ | ✓ | ✕ |
| No manufacturer targets to hit | ✓ | ✕ | ✓ |
| Crews familiar with homes like yours | ✓ | ✕ | ✓ |
Homeowners on how the visit went
“Called three places. This was the only one where a person answered on the first ring.”
Ted N.Luverne, AL“Microwave over the range went dark. They swapped the fuse and door switch and warned me what to watch for.”
Iris B.Eutaw, AL“They remembered the model from my last call and brought the matching part. That is a company paying attention.”
Walt G.Hartford, ALDryer Repair — quick answers
Why does my dryer take three cycles to dry one load?
Almost always airflow. Lint collects in the duct, the blower slows down, and moist air just sits in the drum. We measure exhaust flow and inspect the vent run before we touch internal parts, since a duct problem imitates a heater problem closely.
Is a dryer that doesn't heat worth repairing?
Usually yes. No-heat faults come from fuses, thermostats, and elements, which bolt in on most models. We also look at why the part failed, because a blown thermal fuse often means the vent let the machine overheat.
Gas or electric, do you handle both?
Both. Electric dryers fail at elements and fuses. Gas models add igniters, flame sensors, and gas valve coils. The diagnosis path is different, so tell us which type you have when you call us.
My dryer shakes the whole floor. Dangerous?
Noisy, mostly. Thumping usually means drum rollers or a bearing wearing flat. Left alone, a failed roller can scar the drum or strain the motor, so it's better handled while it's still just noise.
Should I clean the vent myself?
Clean the lint screen every load and the outside flap monthly. The full duct run needs tools and a real inspection, especially long runs or ones that terminate at the roof. We check that line as part of a dryer visit.
How long does a typical dryer repair take?
Many finish in one visit once we know the fault. Belts, fuses, rollers, and elements ride on the van. An uncommon control board may need an order and a return trip.
How it works
- Step 1
Describe the symptom
Tell us what you hear, smell, or see. Is it grinding, is there a puddle on the floor, is a code blinking at you? Small details narrow the list of likely causes before we ever pull the machine away from the wall.
- Step 2
We examine the machine
A technician works a checklist: power, controls, sensors, motors, seals, drainage. We test instead of guessing. Then we walk you through the actual fault and what your repair options are.
- Step 3
You choose the treatment
Some faults are worth fixing the same day. Others mean the appliance is near the end of its life. We tell you which one you're looking at, and we finish the repair once you say go.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- We think like diagnosticiansSwapping parts until something works costs you time. We trace the symptom back to its cause and confirm it with a test, then repair the thing that actually failed rather than the thing that merely looked suspicious.
- Second opinions are fine by usSomeone already told you the compressor is done, or that the control board is fried? Bring us in to check. We'll run our own examination and tell you honestly whether that diagnosis holds up.
- Brand-independent serviceWe're an independent repair company, and we work on refrigerators, washers, dryers, dishwashers, ovens, ranges, and freezers from all major brands. No brand steers our recommendation toward replacement over repair.
- Straight talk on repair or replaceNot every appliance deserves a rescue. If the numbers and the condition point toward a new unit, we say so. What you get is facts about your machine, not pressure to book work.
- All major brands, gas & electricEvery major appliance brand, gas and electric, handled by an independent shop.
- Straight answersWhen a repair doesn't make sense, we tell you, sometimes before we even roll a truck.
Dryer Repair
Small faults become big ones on a schedule of their own
Describe the symptoms and we'll book the visit — takes about a minute.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →