Dryer Repair in Selmont-West Selmont — Book a Visit Today

Two loads to dry one load? That is a symptom, not a habit. So is a drum that turns with no heat, a squeal that grows louder, or a dryer that quits mid-cycle. Heating element, thermal fuse, blower wheel, airflow — we check them in order. Selmont-West Selmont laundry rooms see all of it. Describe the noise or the timing, or send the quote form.

Real person answers
Open 7 days
Written quotes

Call (800) 712-6387

A real person answers
Open 7 days
Written quote before work starts

Taking calls until 5:00 PM CT

Dryer Repair technician in Selmont-West Selmont, AL

Common dryer faults in Selmont-West Selmont homes

Runs a full cycle and clothes are still wet Airflow restriction or partial heat loss — clogged vent, weak blower, failing element or thermostat
Drum spins but there's no heat at all Open thermal fuse, burned heating element, bad high-limit thermostat, or half the 240V supply lost
Loud thumping or squealing while it tumbles Worn drum rollers, dry idler pulley, stretched belt, or a rear bearing giving out
Smells hot or scorched near the laundry room Lint buildup against the heater housing or a blocked exhaust holding heat inside the cabinet
Push start and nothing happens Door switch, start switch, motor centrifugal switch, or a control board that lost its signal

Selmont-West Selmont coverage

We cover Selmont-West Selmont and the 36701, 36702, 36703, 36775 and 36785 ZIPs, plus nearby Selma, Valley Grande, Marion and Uniontown.

Other repairs we do in Selmont-West Selmont

All dryer repair → · All Selmont-West Selmont services →

Dryer Repair in Selmont-West Selmont — quick answers

Why does my dryer take three cycles to dry one load?

Almost always airflow. Lint collects in the duct, the blower slows, and moist air stays in the drum. We measure exhaust flow and inspect the vent run before touching internal parts, since a duct problem imitates a heater problem closely.'

Is a dryer that doesn't heat worth repairing?

Usually yes. No-heat faults come from fuses, thermostats, and elements — bolt-in parts on most models. We check the cause of the failure too, because a blown thermal fuse often means the vent overheated the machine.

Gas or electric — do you handle both?

Both. Electric dryers fail at elements and fuses. Gas models add igniters, flame sensors, and gas valve coils. The diagnosis path differs, so tell us which type you have when you call us.

My dryer shakes the whole floor. Dangerous?

Noisy, mostly. Thumping usually means drum rollers or a bearing wearing flat. Left alone, a failed roller can scar the drum or strain the motor, so it's better handled while it's still just noise.

Do you come out to Selmont-West Selmont for one appliance?

Yes. One washer, one oven, one ice maker — a single symptom is enough. Call us and describe what it does and when it started.

How it works

Step 1
Describe the symptom
Tell us what you hear, smell, or see. Grinding? Puddle? Blinking code? Small details narrow the list of likely causes before we ever pull the machine away from the wall.
Step 2
We examine the machine
A technician runs through a checklist: power, controls, sensors, motors, seals, drainage. We test instead of guessing, then walk you through the actual fault and your repair options.
Step 3
You choose the treatment
Some faults are worth fixing today. Others mean the appliance is near the end. We tell you which is which, then complete the repair once you say go.

Call (800) 712-6387

A real person answers
Open 7 days
Written quote before work starts

Questions worth asking any repair company

Ask these of anyone you let into your home — us included. Call and we'll answer all five before you book anything.

1Ask for their license numberThen verify it with your state licensing board rather than taking it on trust.
2Ask for proof of insuranceLiability cover protects you if something goes wrong in your home.
3Get the quote in writingIncluding the trip fee, whether it's credited against the repair, and parts.
4Ask how they handle callbacksIf the same fault returns, what happens? Get the answer before work begins.
5Check their own reviewsLook the business up independently — their Google profile, not just what they tell you.

Why homeowners call us

We think like diagnosticiansSwapping parts until something works costs you time. We trace the symptom back to its cause, confirm it with a test, and repair the thing that actually failed instead of the thing that looked suspicious.
Second opinions are fine by usSomeone already told you the compressor is done, or the control board is fried? Bring us in to check. We'll do our own examination and tell you honestly whether that diagnosis holds up.
Brand-independent serviceWe are an independent repair company working on refrigerators, washers, dryers, dishwashers, ovens, ranges, and freezers from all major brands. No brand steers our recommendation toward replacement over repair.
Straight talk on repair or replaceNot every appliance deserves a rescue. If the numbers and the condition point toward a new unit, we say so. You get facts about your machine, not pressure to book work.
All major brands, gas & electricWhirlpool, Samsung, LG, GE, Maytag, Bosch, KitchenAid and more — as an independent repair company.
Straight answersIf it isn't worth repairing, we'll say so — often on the phone.